Digiop BLK-IPS101 Guia de Configuração descarregar pdf (Página 8)

www.digiop.com

• Lighting – Is there enough light in the eld for the camera to “see” clearly? Is there intense light from the sun or shiny objects

that reect onto the camera lens? These conditions may aect the video quality and camera performance.

• Ease of installation – Must be able to install the camera at the location, considering mounting hardware requirements,

temperature, dust, moisture, etc.

DIGIOP® recommends that you bench test your cameras and cables before installing them.

Weatherproof cameras

Weatherproof cameras can be mounted in any open area, such as on a telephone pole or on the side of a building. However, for best

results, we recommend you mount your cameras in a sheltered area, such as under the eave or roof of a building. Point the camera

in the direction you wish to observe. When routing cable near the camera, allow enough slack to form a “U” shaped drop to help

direct moisture, that accumulates on the cable, away from the camera.

NOTE

Cable connections are not weatherproof.

Cable runs

LAN/power cables can be run almost anywhere, and are frequently routed above drop/acoustic ceilings because of the ease of

installation. For added security, we recommend you run your cables in areas with limited access to prevent tampering. Avoid

running the cable near high voltage appliances such as uorescent lighting. Electrical noise and magnetic elds produced by these

devices may aect video signal quality.

NVR/hDVR placement

Your monitoring and recording equipment is central to the accurate capture of video evidence and constant surveillance. DIGIOP®

strongly suggests that it be installed in a secure location with access limited to authorized personnel. Additionally, NVRs and

hDVRs generate heat and should be placed in a well ventilated area. Excessive heat will reduce the life span and reliability of the

equipment.

The monitor does NOT need to be on for recording to take place. NVRs and hDVRs will output and record video regardless of the

operational status of the monitor.

Uninterruptible power supplies

It is strongly suggested that power to the system be routed through an uninterruptible power supply (UPS). These devices will keep

your security system running through most power outages, in addition to providing excellent voltage surge and drop protection.

The UPS should support your video recorder and all cameras to ensure operation during power outages.

SECTION 2: GETTING STARTED: UNPACKING YOUR SYSTEM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 46 47

Sem comentários

Digiop BLK-IPS101 Guia de Configuração Página 8